Setting up a Brick Paver Walkway or Big Grey Bricks

The usage of Installing a Brick Paver Walkway or Brick Hammer or Pavers to produce a walkway or patio area matches a house in a manner in which is unequaled. It includes a level of quality and sophistication to a home entryway that can not be attained with either concrete or asphalt. Brick and Pavers likewise can be found in lots of various colors and shapes allowing for unique color plans and patterns to be accomplished. In addition, setting up a Brick or Paver walkway does not always require a pro. With some basic knowledge and a relatively basic sidewalk strategy, a homeowner is capable of carrying out such a job.

The key to installing a Brick or Paver Walkway is to very first correctly prepare the location where the bricks/pavers are to be installed. In addition, string lines need to be strung on each side of the sidewalk.
When the area has been dug down, 3/4" gravel stone should be laid in and tamped down securely. The height in between the tamped down sand and the stringline must equal the thickness of the brick or paver.

Now that you have a steady base, position a 1" pipeline or ledger board the length of the walkway on either side of the sidewalk. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will produce a level surface area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Set up a run on both sides of the prepared area. These strips will act as your walkway border check here and help to maintain the integrity and shape of the sidewalk.

Once this is done, you can then start to lay the bricks/pavers. There are lots of patterns you can lay. I especially like the Herring Bone pattern. The key to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will once again assist maintain the integrity of the pathway.

When developing the pathway, inevitably bricks/pavers will need to be cut or divided. Unless you wish to buy or rent an expensive wetsaw, I would suggest buying a basic brick/paver splitter. It is basically a chisel with a broad end that is the width of the bricks/pavers. To really cut/split the brick/paver, lay it in a bed of sand and location the sculpt at a 75 degree angle over the area where you desire to break the brick. Then utilizing a hammer strike the butt end of the sculpt securely. You might require to do this a number of times. You might also wish to flip the brick/paver over and strike the other side of the brick utilizing website the hammer and chisle. Within a couple of strikes the brick/paver ought to break cleanly. If your pathway has curves you will need to buy/rent a wetsaw.

After installing the bricks, construct up the outdoors edges with additional sand, and then shovel in the topsoil and load down securely.
Spread stone dust over the new sidewalk and sweep into the cracks. This will finish the interlocking of the bricks and assist to get rid of any weed growth.


In addition, setting up a Brick or Paver pathway does not always need a pro. The key to installing a Brick or Paver Walkway is to first properly prepare the area where the bricks/pavers are to be installed. Now that you have a stable base, place a 1" pipe or ledger board the length of the walkway on either side of the pathway. These strips will more info act as your pathway border and assistance to keep the integrity and shape of the walkway. Undoubtedly bricks/pavers will need to be cut or split when building the walkway.

Leave a Reply

Your email address will not be published. Required fields are marked *